Koolance RP-980SL - Manual (Page 24)

19 User Manual
Testing & Filling
Once all of the coolers have been connected, the system can be fi lled with coolant.
The refi ll plug is located on top of the reservoir bay unit.
Free this component by removing its side drive screws. Slowly pull it out just enough
to expose the refi ll plug (about 2.75”, 7cm).
Depending on your chassis
design, you may need to hold
the bay unit with one hand
to support it during the fi lling
process.
Unscrew the small metal refi ll
plug by hand. If it is too tight,
use pliers to loosen it gently.
To avoid damaging the tank
threading, never use tools to
tighten the metal refi ll plug
when screwing it back in.
WARNING :
The liquid coolant is electrically conductive. Use caution
when fi lling the system, and keep all liquids away from computer
hardware and power cables. In case of emergency during installation,
immediately unplug the computer’s rear power supply cable. Dry the
system thoroughly before proceeding.
!
Slowly fi ll the system using
the supplied bottle and fun-
nel. To maintain the product
warranty, use only Koolance
approved coolant.
Many alternative “liquid
coolants” and additives can
cause permanent damage
to Koolance equipment and
computer hardware.