Koolance TMS-EB200 - Manual

Hardware Installation
The TMS interface card can be installed into a PCI or PCI-Express slot (with the included L-bracket), or mounted into a 5.25” bay
(using the included tray). All communication occurs via an external or internal USB port, even when installed into a motherboard
slot. The TMS hardware board is powered by a direct 12V power supply connection.
First, power-down the computer and connect all necessary wires to the TMS card. DO NOT CONNECT THE USB CABLE TO
THE COMPUTER. The internal or external USB cable will be connected to the computer after software installation. If needed,
extension wires for fans and the pump are included with the TMS board.
Koolance TMS-200 Installation Guide
v1.02
1
External USB Connection
Connection
Indicator
LED
Internal USB Connection
Temperature sensor
connections (#1 - 5)
Coolant fl ow meter LED switch (INS-FM16
only): off, on, or pulse according to fl ow rate
*Pump power connection:
*CAUTION: Only Koolance pump models PMP-400 and PMP-450 are
compatible with TMS-200. The PMP-400 is found in Koolance PC4-1000,
RP-1000, and TNK-400 series products. Other models (such as the PC2,
PC3, Exos-1/LT, etc.) may damage the TMS board or computer power
supply if connected.
!
**ATX pass-through wire: enables the hardware safety shutdown feature. Connect the
male ATX power lead from theTMS board to the computer chassis main power switch.
12V 4-pin Molex power
supply connection
Connect the other female ATX power lead to the
motherboard’s power switch connection (often
marked “PWRSW”, “PWSW”, or “PWBT”).
This is the connection that would normally
receive the chassis power switch lead directly.
INS-FM16 Coolant fl ow meter
(sold separately)
INS-FM17 Coolant fl ow meter
(sold separately)
**ATX Pass-through wire: Fan power connections
(#1 - 3)