Koolance TMS-EB200 - Manual (Page 2)

Koolance TMS-200 Installation Guide
v1.02
2
Expansion Board Installation
The expansion board includes a standoff and two screws. Attach the
standoff to the top side of the TMS main board in the hole near the
dummy slot.
Make sure the connecting pins are aligned properly, and carefully insert the expansion board
into the TMS main board.
The expansion board’s fan and temperature connections should face in the same direction as
the TMS main board connections. DO NOT INSTALL IT BACKWARDS!
Mounting
If the TMS-200 hardware board will be installed into an available motherboard slot, attach the included
I/O L-bracket with the smaller supplied screws.
NOTE: If using the optional expansion board with TMS-200,
the TMS hardware card will require two motherboard slots
instead of one.
If the hardware board will be installed into an available 5.25” bay, attach the included metal
tray with the larger supplied screws.
Finally, install the second screw to secure the expansion board to the standoff.
CAUTION: The TMS expansion board must be aligned properly (top fan connectors
in the same direction as the main board fan connectors). Otherwise, permanent
hardware damage could result.
!
If you have purchased the optional
daughter expansion board for TMS-200,
please read this section. Otherwise, skip
to “Mounting” below.
Connect all necessary wires to the TMS
expansion board. If needed, extension
wires for fans and the pump are included
with the board.
Coolant fl ow meter LED
switch (INS-FM16 only): off,
on, or pulse according to
fl ow rate
Pump #2 power (Same
pump models allowed as the
main board)
INS-FM16 Coolant
fl ow meter
(sold separately)
INS-FM17 Coolant
fl ow meter
(sold separately)
Fan power connections
(#4 - 6)
Temperature sensor
connections (#6 - 10)
Decide whether the TMS card will use the L-bracket (motherboard slot installation) or 5.25” tray (drive bay installation) and mount the
appropriate piece with the included screws. To help avoid physical damage, it is suggested to attach all necessary cables to the TMS
hardware before mounting the TMS board.