Britax Diplomat P321900 - Manual (Page 18)

16
Lift the child seat cover and open the rear-facing 2
lock-off farthest from where the vehicle belt will
be buckled (Fig. B).
Pull the vehicle belt out then pass it through the 3
rear-facing belt slot (Fig. C).
The vehicle belt can be routed over or under the •
child seat cover.
Route the vehicle belt across the child seat then 4
through the opposite rear-facing belt slot.
The vehicle belt must rest behind the child seat •
buckle strap.
Verify that the vehicle belt is not twisted, position 5
the belt through the open lock-off, then buckle
(Fig. D).
Push the child seat firmly into the vehicle seat 6
while removing the slack from the vehicle belt.
Tighten the belt, close the lock-off arm (Fig. E) 7
and replace the cover.
The lock-off is properly closed when a positive click •
is heard.
Lap-Belt Installation
Figure A illustrates a typical rear-facing, lap-belt •
installation.
When not in use, always store the LCS connectors in •
storage slots. See page 29.
Recline the child seat and place it rear-facing on 1
the vehicle seat.
Installation : Rear-facing
b
C
D
WARNING! This child seat must be in the
recline position when installed rear-facing. See
Recline Adjustment on page 29.
A
Rear-Facing