Britax Diplomat P321900 - Manual (Page 24)

22
Lap-Belt Installation
Figure A illustrates a typical forward-facing, lap- •
belt installation.
When not in use, always store the LCS connectors •
in the storage slots. See page 29.
Place the child seat forward-facing on the vehicle 1
seat. Ensure the bottom of the child seat base is in
full contact with the vehicle seat.
Remove the Versa-Tether from the pouch and 2
place it up and over the child seat back.
Pull the vehicle belt out, then pass it through the 3
forward-facing belt path to the opposite side of
the child seat (Fig. B).
Verify that the vehicle belt is not twisted, then buckle (Fig. C). 4
Push the child seat firmly into vehicle seat while removing slack from 5
the vehicle belt.
Attach the Versa-Tether 6 ® hook to the designated tether anchor for the
chosen seating position. Remove all the slack from the tether to secure.
Store any excess webbing in the tether pouch. See pages 25 – 27.
Installation : Forward-Facing
C
b
A
Forward-Facing WARNING!
This child seat must NOT be used forward- •
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
This child seat must be in the upright position •
when installed forward-facing.
Always use the Versa-Tether when the child •
seat is installed forward-facing. Check your
vehicle owner’s manual for approved tether
anchor locations.