Britax Diplomat P321900 - Manual (Page 30)

28
Switching the Lower Connector System
(LCS)
The LCS strap may need to be switched to the proper
belt path in rear-facing (Fig. A) versus forward-
facing (Fig. B) installations. If a proper connection
of the LCS connectors to the LUAS anchors cannot
be achieved, complete the following procedure to
switch the connectors.
Lift the front of the child seat cover to access the 1
LCS connectors.
Pass the LCS connector strap through the belt 2
path on the child’s right side (Fig. C).
Pass one LCS connector through the appropriate 3
belt path ensuring that the larger part of the
connector is on top for the installation procedure
you wish to use (Fig D).
Verify that the harness is not twisted. •
When installing this child seat in rear-facing mode, •
the LCS strap must rest behind the child seat buckle
strap.
NOTE: To ensure LCS connector is properly aligned
with vehicle’s LUAS anchor, the connector’s red
release button should face away from vehicle seat
back, and the larger of the two connector sections
is on top (Fig. D).
Replace the cover and continue with the 4
installation procedure.
Child Seat Functions
A
b
D
Top
Release
Button
C