Landoll FPSBT-6 Food Plot Seeder - Manual (Page 21)

3-1
Chapter 3
Assembly

CAUTION
The intent of this chapter is to provide instruction,
allowing you to safely and correctly assemble your
Brillion product.
IMPORTANT
If a pre-assembled component or fastener is
temporarily removed, ensure it is correctly
re-installed per these instructions.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
• Park the seeder in a work area that has a level
surface and make sure it is blocked securely so that it
cannot roll.
Seeder Assembly
Support the frame and seedbox assembly with a hoist or
by similar means capable of supporting its weight without
tipping.
NOTE
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
Figure 3-1: Pull Type Seeder Drawbar Installation
Do not work on or under this machine unless
securely
blocked and supported by a hoist or
tractor or by other sufficient means!