Landoll FPSBT-6 Food Plot Seeder - Manual (Page 29)

ASSEMBLY
3-9
Optional Rock Box
• Attach Rock Box to Frame angles just in front of the
Seedbox with 1/2-13 x 1-1/2 Capscrews, Flat Washers
and Lock Nuts. See Figure 3-11.
Figure 3-11: Rock Box
Optional Positive Drive Roller
1. Remove Scraper Assembly and set it aside.
2. Remove Upper and Lower Chain Guards, Primary
Drive Chain and Firming Roller.
3. Remove Sprocket from Firming Roller and re-install it
onto Positive Drive Roller in the same position.
4. Install roller, chain and guards onto the Frame in
reverse order of disassembly.
5. Starting with the left side of the scraper assembly,
move the second scraper so the gap between it and
the first is 3-5/16". Continue to adjust gap between
each scraper to 3-5/16". Do not tighten hardware.
One scraper will need not be used with positive drive
roller.
6. Reinstall scraper assembly to seeder and fine tune
scraper adjustment. Tighten scraper hardware with
roller lowered on level surface. See Figure 3-12.
.
Figure 3-12: Positive Drive Roller