Lenze CANopen Controller-based Automation - Manual (Page 60)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17
60
8 Commissioning of the CANopen Logic bus
8.11 Preparing the restart
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.11.1 Special features of the 9400 Servo Drives HighLine
Servo Drives 9400 are not purely parameterisable devices. They require an application download,
where several files are transmitted to the memory module.
To put a Servo Drive 9400 into operation, you can:
• plug on the memory module.
• transmit the application using the »Engineer«. For this, you must keep the original »Engineer«
project.
• transmit the application using the »Loader«. For this, you must export and keep the required
files from the »Engineer« project:
8.11.2 Special features of the 8400 Inverter Drives
Inverter Drives 8400 are purely parameterisable devices.
To put an Inverter Drives 8400 into operation, you can transmit the application using the
»Engineer«. For this, you must keep the original »Engineer« project.