Broadband Products PC5220 - Manual (Page 11)

Connecting the PC5220 and Drivers to your Laptop PC
1. Insert the PC5220 into your laptop PC’s PC Card Slot with the label facing up. Then,
raise the antenna so that it is fully extended and pointed up at a 90° angle. Use in any
other configuration may exceed FCC RF Exposure Limits.
2. Once you have inserted the card properly, your Windows operating system will notify you
that new hardware has been detected.
NOTE:
Windows XP only:
The Hardware Detection Wizard will launch upon insertion of the PC5220. Follow the on screen
instructions. This three-step wizard process will perform five times. The Found New Hardware
Wizard may appear asking to select a USB Root Hub. If so, click Next to continue, accepting the
already highlighted default USB Root Hub.
NOTE:
Windows 2000 and XP only:
A “Digital Signature Not Found” window may appear more than once. Please disregard the notice
and click Yes or Continue Anyway to proceed with installation.
WARNING: Once the card is inserted, do not physically remove the PC5220 until
you have completed the Unplug/Eject process. Removing the card improperly may
cause a fatal error.
Note:
Before inserting the PC5220 into your laptop PC’s PC Card slot, it is recommended
that you remove the Installation CD from your CD-ROM drive.
driver: a driver acts like
a translator between the
device and programs that
use the device.
8