Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 251)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 249
12.7.8 Connect Selected Pins
Symbol:
This command (category CFC) is only enabled when exactly one output pin and one or
several input pins are selected. When executed, a connection between the output pin
and the input pin(s) is established.
12.7.9 Reset Pins
Symbol:
If unused input or output pins have been removed from a box in the CFC Editor, for
example because they are not used, or if the interface of the POU which is represented
by the box has been changed, this command (category CFC) can be used to restore
resp. update the display of the pins. It can also be used to display the parameters of
type VAR_IN_OUT of a function block, which are hidden per default.
In the following example input fbin2 of a function block instance had been deleted
because it is not used. By selecting the fb1 box and using command 'Restore Pins' all
inputs and outputs of the function block, as defined in its implementation, can be
displayed again.
Abb. 85 Reset Pins, example
12.7.10 Remove unused pins
Symbol:
This command (category CFC) removes non-connected pins from program, function
block or non-local action calls in the current editor selection. This will not be done for
function, method or operator calls as this would lead to invalid syntax.