Installation and setup instructions, Wiring introduction – Longevity ARCMATE 205 User Manual
Page 14
160/205 MIG Welder/ARC Welder
Page 13 of 37
www.longevity-inc.com
Installation and Setup Instructions:
The item numbers referenced in the following paragraphs, refer to the numbered parts display in the
diagrams shown below. Longevity has an instructional setup installation video on our website at
hich we ask that you view prior installing the unit. The video shows the
complete assembly of the machine. The video is located in the Resources section of the website under
manuals and installation/set-up videos.
Connecting the electrical plug to the unit
Connecting the power plug to the unit is important. Please view the proper connection instructions below:
Wiring Introduction:
Danger: Read this manual completely before having your electrician attempt to wire up or connect your
machine to an electrical power source. Longevity units should be wired by a certified electrician to insure
your safety and a proper 220v plug match at your operating facility. 220v plugs come with 3 or 4 prongs
on them. Have the electrician check your existing receptacle.
Note: The power cord on single-phase machines has one ground wire and two hot wires when
connecting to 220vac. Connecting the plug connection to these wires is extremely important.
Improperly connected wires will void the warranty, affect personnel safety, and possibly damage your
machine and electrical power outlet.