Mayline 6' Adder for Conference Table - Manual (Page 2)

3. Partially install Screws (E3) into the bottom hole on both sides of the
Adder Leg (1) so that the screw heads are approximately 1/8" from the leg.
4. Using the key hole slots in the ends of the Trough Assembly (3),
attach Trough Assembly to Adder Leg. Tighten two Screws holding trough.
(2)
1. Install threaded inserts (E1) into Adder Leg (1).
2. Thread Glides (E2) into threaded inserts installed in Step 1.