Mayline 6' Adder for Conference Table User Manual
Page 4
(4)
13.
Position Starter Worksurface over Starter Base and loosely fasten in place using
hardware and instructions supplied with that product. Position Adder Worksurface (4) on
Adder base and loosely fasten using screws (E4) through legs, spreader and connector
panels.
14.
Continue the Conference Table assembly by installing another Adder worksurface
or complete the Conference Table by installing the final worksurface.
Once ALL tops are installed and aligned, tighten all screws.
15.
Insert slam latch (E6) into Access Panels (5 & 6).
16.
Install the Access Panels into the table base by inserting Panel tabs into Trough
(3) slots. Pivot panels up until latch catches on spreader.
17.
Insert Grommet (10) into hole in Worksurface (4) and fasten using Screws (E9).
18.
Attach Standoffs (E8) to Wire Cover (11).
19.
Adhere Felt Pads (E7) to the bottom of Standoffs (E8).