Mayline 6' Adder for Conference Table - Manual (Page 3)

(3)
5. Assemble Starter Base per instructions included with that product.
6. Move assembled Adder Base into position. Using the key hole slots in
Trough end (3), attach the Trough to the partially installed screws in the
assembled Starter Base.
7. Install two Spreaders (2) to Adder Leg (1) and to assembled Starter
Base using Screws (E3).
8. TIGHTEN ALL SCREWS mounting Spreaders and Trough.
9. Continue the Conference Table assembly by joining another Adder
Base or complete the Conference Table by joining the final section.
Hole
remains
OPEN
10. Install Slam Latch (E5) into Inner Leg Panel slot (7) as shown.
11. Insert Inner Leg Panel (7) into Adder leg foot slots. Rotate Inner
Leg Panel till slam latch catches Trough Assembly (3).
12. Position Connector Panels (8 & 9) as shown in detail. Attach
Connector Panels (8 & 9) to Trough Assembly (3) using screws (E3).
Partially
installed
screws
Starter Base