MBT Lighting LEDPAR64PRO (SRL-6057SB) - Manual (Page 7)

LEDPAR64PRO
7
PART II Installation and Operation (continued)
D. DMX addressing
All fixtures should be given a DMX starting address when using a DMX controller, so the
correct fixture responds to the correct control signal. This digital starting address is the
channel number from which the fixture starts to "listen" to the DMX control information
sent out from the DMX controller. The allocation of this starting DMX address is achieved
by combining various dipswitches. Please refer to related sections for further
information.
2.4 Operation Instructions
The fixture employs two groups of dipswitches to access its functions. Normally the
dipswitches from 1
st to 9 th are used for encoding DMX address. In addition, the unit
features an easy-to-understand LED digital display to shows what modes or status it is
working in. For example, if the display shows: Axxx, it means that the machine is working
in DMX mode. Following table detailed the information.
LED displays
Meaning
Axxx DMX mode
Pxxx Auto /Master
Px.x.x Sound active/Master
Sxxx Slave mode
Dipswitch 1 address equals to 1
Dipswitch 2 address equals to 2
Dipswitch 3 address equals to 4
Dipswitch 4 address equals to 8
Dipswitch 5 address equals to 16
Dipswitch 6 address equals to 32
A000