MEElectronics Air-Fi Matrix AF62 - Manual (Page 11)

08
Pairing with Bluetooth Devices
*** It is only necessary to pair your Matrix once with each device ***
iPhone, iPad, and iPod Touch
On your iPhone/iPad/iPod Touch, go to Settings
Select Bluetooth (on devices with iOS 5.1.1 or older,
Bluetooth is under the General menu)
Make sure the Matrix is off and within 1 meter of your device
On your iPhone/iPad/iPod Touch make sure Bluetooth
is turned on
Initiate pairing mode by pressing the Power/Call button for 6
seconds, until you hear “ready to pair.”
(Note: the first time you use your Matrix it will automatically
enter pairing mode when powered on.)
The Matrix will offer voice prompts to assist in pairing in a
repeating cycle until it is either connected or powered off.
(Note: Pairing mode will be active for 5 minutes.
If no devices are paired within that time, the Matrix will
return to standby mode.)
Wait until you see “AF62” in the Devices section of the screen; it
should show “Not Paired” as the status
Select on “AF62” to pair and connect your
iPhone/iPad/iPod Touch to the Matrix
The Matrix will say “pairing completed” once pairing is complete.
“AF62” should show “connected” on your device; the blue LED
will be on continuously when connected
If pairing fails, please repeat steps c) through h) above
a)
b)
c)
d)
e)
f)
g)
h)