New Buck Corporation DV1000 - Manual (Page 26)

WIRING DIAGRAM
MOTOR
RHEOSTAT
THERMOSTAT
GREEN
JUMPER
WHITE
BLACK
BLACK
JUMPER
JUMPER
POWER CORD
NOTE: “If any of the original wire as supplied with the gas appliance must be replaced, it
must be replaced with a wire of at least a 105
o C. temperature rating.”
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can
cause improper and dangerous operation.
Verify proper operation after servicing.
WARNING:
ELECTRICAL GROUNDING INSTRUCTION:
THIS APPLIANCE IS EQUIPPED WITH A THREE-PRONG (GROUNDING) PLUG
FOR YOUR PROTECTION AGAINST SHOCK HAZARD AND SHOULD BE
PLUGGED DIRECTLY INTO A PROPERLY GROUNDED THREE-PRONG
RECEPTACLE.
FOR YOUR SAFETY : DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
WARNING:
DO NOT USE A BLOWER INSERT , HEAT EXCHANGER OR OTHER
ACCESSORY NOT APPROVED FOR USE WITH THIS HEATER.
Optional Blower Kit: #MA DV1000714. (Standard with XL package.)
Page 23