New Buck Corporation DV1000 - Manual (Page 7)

1. The top louver assembly must be removed first. To remove the top louver assembly you must
place your hands one at the bottom left corner and the other at the bottom right corner of the lou-
ver assembly. Then with both hands lift up and outwards to release the louver clips from the
stove body. After removing the louver assembly place it in a safe place until time to reinstall.
2. The bottom louver assembly must be in the open position to access the firebox cover door fas-
teners. The bottom louver assembly is hinged to the bottom of the stove. Place one hand on the
center of the top louver and pull slowly out and downward to open.
3. Before removing the firebox cover door you must remove the six (6) 1/4-20 nuts located across
the top of the door and the bottom of the door. After removing the nuts you must slowly pull the
door outward and completely off the studs. Place the door in a safe place until time to reinstall,
the glass is breakable.
NOTE: The Firebox Cover Door must be removed to access the pilot assembly located in the right
rear corner of the firebox area, and to access the burner pan located in the bottom center of the
firebox area. The door must also be removed when placing the logs and embers.
4. To replace the cover door, reverse steps 3 thru 2.
#1 SIDE VIEW OF
LOUVER ASSEMBLY
AND CLIP.
WARNING: “Do not operate
appliance with the glass front
removed, cracked or broken.
Replacement of the glass should be
done by a licensed or qualified
service person.”
1/4-20 NUTS
SLOT IN STOVE BODY FRONT FOR LOU-
VER ASSEMBLY CLIP TO SECURE TO
STOVE BODY.
#1
#2
#3
1. TOP LOUVER ASSEMBLY
2. BOTTOM LOUVER ASSEMBLY
3. FIREBOX COVER DOOR
LEFT SIDE
RIGHT SIDE
FRONT
FIGURE 1
Replace the entire cover door assembly if glass
becomes defective with part # PO COVDOR1.
Page 4