MMF POS VAL-u LinePLUS Series - Manual (Page 5)

VAL- u LinePLUS User Manual
Last Revision 7/6/2010
4
Replacement / Removal of components
Inner Drawer Removal
 Open the cash drawer and remove the currency tray.
 Place both hands on the front sides of the inner
drawer and lift the cash drawer up (Approximately 1/4"). Pull
the inner drawer all the way out of the cabinet.
Inner Drawer Replacement
 Pull the inner drawer’s ball bearing slides back as far as
possible; unite and align the side rails mounted to the inner
drawer
with the side rails mounted on the cash drawer
housing walls.
 Lift the drawer up (Approximately 1/4") just before it touches the top, and then
drive the drawer into the cash drawer housing until its in place.
 Push the inner drawer to the closed position.
 When the inner drawer is fully in the closed position, open it and close it a few times to
verify proper functionality. Then, re-insert currency tray inside cash drawer.
Lock Removal
 Remove the inner drawer as directed above. Flip Inner drawer over.
 Rotate lock cam until screw on top is showing. Unscrew it to disengage
from lock rod. Pull lock cam and remove lock assembly.
Lock Replacement
 Connect new lock cam to lock rod by orienting the lock rod to the side
opening of the lock as illustrated.
 Place the new lock cam in place behind the inner drawer’s front panel.
 Place the new lock assembly through the lock opening in the front panel
of the inner drawer and attach to lock rod by pressing the lock cam into
the lock assembly.
For replacement parts and/or
accessories, contact your supplier
or visit our website at
http://www.mmfpos.com
If you experience resistance on the
slide bearings as you close the drawer
make sure the slides are fully engaged
and properly lubricated.
Lock Cam
Lock Rod