MTS Series 793 Application - Manual (Page 381)

Periodic Time Event Process
MTS MultiPurpose TestWare® Event Process Descriptions 381
How to Define a Periodic Time Event Process
1. Drag the icon from the Process Palette to your procedure table.
2. Click the process icon in your procedure table or in the navigation pane.
3. Click the Settings tab.
Note Double-clicking an entry box displays its selection list.
4. Type or select desired values in the Minute, Hour, Day of Week, Day of
Month, and Month of Year entry boxes.
5. Click the Options tab.
6. Under Trigger Mode, set the trigger mode. If Trigger for Duration is
selected, set the End After time.
7. Optional—Enable (check) the Log Message As control and select the type
of message you wish to generate.
8. Click the General tab.
9. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
10. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
11. In the Execute Process box, type number of times you want the process to
run.
Note Repeating the process will have no effect if you selected Trigger
Continuously in step 6.
12. Optional—In the Counter Type list, click a counter type.
13. Optional—If you enabled a counter, type a Counter Label.
14. Set the desired Start and Interrupt signals for the process in the procedure
table.