MTS Series 793 Application - Manual (Page 92)

MTS MultiPurpose TestWare®
About “Trigger” Signals
Working with MPT Processes 92
Procedure diagram The diagram below illustrates the connections between the processes used in the
trigger signal example. The diagram illustrates how the trigger signal is used.
Start
Start
Interrupt
none
Kathy’s DAQ.Done
Detect P/V.Done
Detect P/V.Trigger
<Procedure>.Start
<Procedure>.Interrupt
Interrupt
<Procedure>.Start
<Procedure>.Interrupt
Kathy’s DAQ.Done
Kathy’s Fatigue.Done
Kathy’s Fatigue.Done
Kathy’s DAQ.Done
<Procedure>.Start
<Procedure>.Interrupt
Start
Kathy’s Fatigue
Interrupt
Detect P/V
<Procedure>.Start
<Procedure>.Interrupt
Kathy’s DAQ.Done
Detect P/V.Done
Detect P/V.Trigger
Detect P/V.Trigger
Detect P/V.Done
Kathy’s Fatigue.Done
<Procedure>.Start
<Procedure>.Interrupt
Kathy’s Fatigue.Done
Detect P/V.Done
Detect P/V.Trigger
<Procedure>.Start
<Procedure>.Interrupt
Note To simplify this illustration, some
of the signals normally available
in this scenario are not shown.