MTS Series 793 Application - Manual (Page 430)

MTS MultiPurpose TestWare®
Set Controller Value Process
Other Process Descriptions 430
Set Controller Value Process
About the Set Controller Value Process
This process can change calculation parameter and calculation variable values
defined in the Station Manager application. You set initial calculation parameter
and calculation variable values with the Calculation Editor.
Typical uses include:
• Changing Station Manager calculation parameter values in calculated input
equations used for control feedback or data acquisition, or changing
calculated output equations used to drive a valve or other output resource.
• Changing Station Manager calculation variable values to execute
conditional calculations
Assigning new values
When you select a calculation parameter or variable, you can set a new value
using one of the following methods:
• By entering a new calculation parameter or variable value in its associated
Value to Set text box.
OR
• By assigning an MPT variable in the Value to Set text box that defines the
parameter or variable value.
Note The calculation parameter and variable values set in Station Manager
will not change to new values until the Set Calculation Parameter
process is triggered.
Optional—use an Operator Information or MPT Calculation process to
change the variable value during the test.