MTS Series 793 Application - Manual (Page 453)

Data Display Process
MTS MultiPurpose TestWare® Other Process Descriptions 453
How to Work with the Data Display Process
Data Display
characteristics
This process is used to view data. The data will not be saved to disk.
• Plots can be enabled and/or disabled.
• Plot settings can be saved.
• The plot will appear when the procedure is locked. Likewise, it will
disappear when the procedure is unlocked.
Note To save the position of the plot window(s), you must save the procedure
(’position’ refers to the location of the plot on your PC monitor). If you
move the plot window from its default position and close the procedure
without saving, the plot window will appear in its default (or last saved)
position.
1. Drag the icon from the Process Palette to your group or procedure table.
2. Click the process icon on the table or in the navigation pane.
3. Click the Plots tab.
4. Select an existing plot or create a new plot.
A. Select an existing plot—Highlight the desired plot.
B. Create a new plot—Click one of the add plot buttons .
5. Type a name for the plot in the Plot Title box.
6. Click the Plot Enabled check box to enable the plot. (If the box is not
checked the plot will be disabled.)
7. Click the Acquisition tab.
8. Select an Acquisition Method.
9. If you select the Peak/Valley Acquisition Method:
A. Select a Master Signal from the pull down menu.
B. Select a Units type for the Sensitivity.
C. Type the desired value for the Sensitivity.
If you select the Level Crossing Acquisition Method:
A. Select a Master Signal from the pull down menu.