MTS Series 793 Application - Manual (Page 77)

MPT Options Editor Specimen Log Tab
MTS MultiPurpose TestWare® MPT Options Editor 77
MPT Options Editor Specimen Log Tab
Use the Specimen Log tab on the MPT Options Editor to filter the messages
written to the MPT Specimen Log. You can also specify what items are
displayed in the Message Logs window.
Access From the MPT control panel or MPT Procedure Editor window, the access path
is:
> Specimen Log tab
Or, from the MPT Procedure Editor window, an alternate path is:
Tools > Options Editor > Specimen Log tab
If your test generates an excessive number of messages, you should filter what
messages are written to the log to avoid exhausting disk space.
For instance, you can change the Source filter from All Applications to This
Application Only to keep Station Manager messages out of the MPT Specimen
Log.
Specimen Log Tab (part 1 of 2)
I TEM D ESCRIPTION
Message Capture Controls the severity level and source of the information that is written to the
MPT Specimen Log.
Minimum Severity sets the severity level that must be reached before a
MultiPurpose TestWare writes a message to the Specimen Log file. There are
five levels:
• Diagnostic—Writes Diagnostic, Information, Warning, Error, and
Fatal Error messages.
• Information—Writes Information, Warning, Error, and Fatal Error
messages; does not write Diagnostic messages.
• Warning—Writes Warning, Error, and Fatal Error messages; does not
write Diagnostic and Information messages.
• Error—Writes Error and Fatal Error messages; does not write
Diagnostic, Information, and Warning messages.