Barco MFGD 2320 - Manual (Page 32)

User manual MFGD 2320 31
It may be possible that dust particles have entered the display and are
stuck to the rear of the glass.
We recommend to let this cleaning procedure be done in a BARCO
service center.
However, when really necessary, you can perform the cleaning on site
if you can work in conditions that are as clean and dust-free as
possible. This is to avoid more dust entering the display when opening
it.
To remove the glass panel:
1 Switch off the display.
2 Tilt the panel.
3 Unscrew the 4 sunken screws at the rear, fixing
the glass panel and bezel.
4 Unplug the cable plugged in on the bezel.
5 Remove the bezel with glass panel.
Cleaning instructions:
- Dust, fingerprints, grease etc. can be removed by using a soft
damp cloth (a small amount of mild detergent can be used on the
cloth, NOT solvent).
- Do not apply liquid directly to the LCD surface as excess liquid may
cause damage to internal electronics.
- Take care not to touch the I-guard light
sensor on the LCD panel.
6. TROUBLESHOOT-
ING
Windows does not show the desired display
settings
Should you have problems selecting display settings for portrait
oriented displays in the Windows Display Properties control panel,
disable the option Hide modes that this monitor cannot display in
the control panel (see below).