Multiquip MC3H - Manual (Page 23)

MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 23
MIX N' GO MIXER — INITIAL START-UP (GASOLINE ENGINE)
Starting the Engine ( HONDA engine)
1. Place the engine fuel valve lever (Figure 20) to the "ON"
position.
DO NOT attempt to operate the mixer until
the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
2. Place the trowel's throttle lever (Figure 21) to the "IDLE"
position.
Figure 20. Engine Fuel Valve Lever (ON Position)
Figure 21. Throttle Lever (Idle Position)
3. Place the choke lever (Figure 22) in the " OPEN " position
if starting a cold engine.
4. Place the choke lever (Figure 23) in the " CLOSED " position
if starting a warm engine or the temperature is warm.
Figure 22. Engine Choke Lever (Open)
Figure 23. Engine Choke Lever (Closed)
5. Place the engine ON/OFF switch (Figure 24) in the " ON "
position.
Figure 24. Engine ON/OFF Switch (ON Position)
This section is intended to assist the operator with the initial
start-up of the walk-behind trowel. It is extremely important that
this section be read carefully before attempting to use the trowel
in the field.