Powertrax 4110 - Manual (Page 11)

11
Figure 6
Install thrust washer on each coupler
Assembly of the LOCK-RIGHT Parts into the
Differential Case
Summary of steps in this section:
a) Install Ring gear side coupler and washer
b) Install other coupler and washer
c) Install left driver and spacer assembly
d) Install other driver
1. Install a coupler and washer assembly in the ring
gear end of the differential case. See Figure 7. Note that the
couplers in some models may have flats for clearance.
2. Place the second coupler and washer assembly into
the other end of the differential case (Figure 7).
3. Important! Be sure to have the spacers correctly ori-
ented and placed in the drivers before doing the following steps!
4. Pick up a driver-and-spacer assembly. Orient its
teeth toward the ring gear flange and hold it so that the flats (if
present) will clear the sides of the case. Place it on the teeth of