Powertrax 4110 User Manual
Page 5
5
LOCK-RIGHT Installations Covered
in This Manual
Removable third member axles. Typical of these are
Toyota® 4-cylinder engine vehicles, both front and rear; similar
appications in Nissan®, Isuzu®; certain domestic applications, etc.
Preliminary Steps
The following steps are only a general guide to prelimi-
nary operations used for preparing your vehicle for LOCK-RIGHT
installation. For detailed information, refer to your shop manual.
In general, the preliminary steps include:
a) Blocking the vehicle, putting transmission in neutral;
b) Loosening the wheel lug nuts (the removal may be
optional; see shop manual);
c) Jacking up the axle; securely resting it on jack stands;
d) Removing the tires (some axles);
e) Disconnecting the brake lines and emergency brake
cables (some axles);
f) Pulling out one or both axles a few inches.
Removal and Disassembly
Summary of steps in this section:
a) Securely block and jack up vehicle
b) Pull out axle shafts by about six inches
c) Remove third member from vehicle
d) Observe ring gear backlash
e) Mark bearing caps and adjusters
f) Remove differential case from carrier
g) Mark bearing races
h) Remove ring gear
i) Remove internal parts
j) Install LOCK-RIGHT