Powertrax 4120 - Manual (Page 11)

11
Figure 7
Place grease in holes for “glue”
5. Inspect the case for any chips, cracks or similar dam-
age. Also inspect the bearings. If the case or bearings look bad,
replace them. However, if you do, remember that the marked
bearing adjuster positions no longer will be correct; the ring and
pinion backlash and bearings pre-load will need to be reset with
a dial indicator as described in the shop manual.
LOCK-RIGHT Installation
Preparing the Parts for Assembly
Coat the teeth of the drivers and both sides of the thrust
washers with medium grease. Also place a little grease in each of
the two window holes in each driver (Figure 7). The grease will
help hold things in place and assist with functioning until the gear
oil circulates.