Powertrax 4120 - Manual (Page 15)

15
Figure 12
Install former bottom side gear & washer on top
and continue with your installation.
4. Insert a small spring into a large spring and place the
assembly into one of the large holes in the bottom driver (Figure
10). Repeat for the other hole. The grease placed in the holes
earlier will help hold things in place.
5. Place a spring assembly into each hole in the other
driver. Place a little more grease on top of the springs to help
hold them in place (see Figure 7).
6. Turn the other driver over and hold it so that the
stop pins line up with the springs in the lower driver. Carefully
lower it until the pins rest on the springs (see Figure 11). Push
it up and down to be absolutely sure that everything is in place
that all springs are functioning properly. Proper operation of the
parts at this point is very important!
7. Place the other spacer in the middle of the top driver.