Replacing driveline clutch – MacDon PW8 Pick-Up Header User Manual
Page 108
6. Sandwich the lip (A) on the driveline bellows between
the hole in the endsheet and the casting (B).
7. Tighten bolt (C)
Figure 4.26
8. Pull back the guard (B) to expose the collar (C) at the
combine end of the driveline (D).
9. Pull back collar (C), and push driveline (D) onto feeder
house shaft until collar locks.
10. Attach tethers (A) that secure driveline guard to header.
Figure 4.27: Combine End
Replacing Driveline Clutch
If the driveline clutch cannot maintain the required torque to operate the header, it must either be repaired or replaced.
Refer to your PW8 Pick-Up Header Parts Catalog (MD #169497) for available replacement parts.
It is recommended that repairs be performed by your MacDon Dealer.
Replace the clutch as follows:
1. Remove driveline from header. See Section
2. Remove the driveline guard (A). Refer to
169489
100
Revision A