MacDon PW8 Pick-Up Header - Manual (Page 113)

MAINTENANCE AND SERVICING
5. Reassemble driveline.
NOTE: The splines are keyed so that universals are
aligned. Align weld (A) with missing spline (B)
when assembling.
Figure 4.37
6. Slide driveline in hook (A) so that disc (B) drops to
secure driveshaft, or connect to combine.
7. Attach tethers (not shown) to header.
Figure 4.38
Driveline Splined Shaft
1. Remove the driveline guard (A). Refer to Removing
Driveline Guard, page 101 .
2. Clean internal and external splines.
3. Install driveline guard. Refer to Installing Driveline
Guard, page 103 .
4.6.3 Draper Drives
The two hydraulic drive motors do not require any maintenance.
If repairs other than motor seal kits are required, they should be removed and serviced at your MacDon Dealer.
Removing Front Hydraulic Motor
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
169489
105
Revision A