Purenex FLECK 5600SXT METER WATER SOFTENER SYSTEMS User Manual
Page 7
- 7 -
FIGURE 13 FIGURE 14
•
Pull the 2310 brine float assembly out of the brine well and disassemble the
retaining nut as shown in Figure 15 below.
•
Next, assemble the 2310 brine float assembly to the brine well through the pre-
drilled hole and hand-tighten as shown in figure 16 below.
FIGURE 15 FIGURE 16
•
Take the other end of your brine line tube and insert the tube through the small
hole drilled through the brine tank, and brine well. Loosely unscrew the hex nut
on the 2310 brine float assembly. Insert the tubing end firmly into the hex nut on
the 2310 brine float assembly.
•
Next back-off the hex nut and ferrule assembly so they are securely onto the
tubing as shown in Figure 17 on the following page.
NOTE: Please be sure to
assemble the nut in the fashion described to prevent system malfunction and
possible brine tank overflow!
•
Hand-tighten the hex nut snugly onto the 2310 brine float assembly as shown in
Figure 18 below.