Retsch PP 40 - Manual (Page 21)

08.02.2012 Retsch GmbH
21
0002
pressing.
You can now “Delete programme” or “Cancel”.
You will then be returned again to the programme mode level
Starting time
Start in xxh xxm
Cancel Starting can be preselected here in steps of 01 to 99 hrs or
01 to 60 min.
The PP40 is started with the preselected parameters after the set starting time has elapsed.
Even though starting without the lid closed is not possible, make
sure that the lid is closed before you start the machine
unattended.
You can interrupt running of the starting time at any time with the STOP button and with the main
switch on the rear side of the unit. You then have to reprogramme the starting time.
Service
MENU SETTINGS
The service menu is divided into four sub-menus:
OPERATING HOURS
The pressing hours are counted, i.e. the total sum of the times between START and STOP. These times
cannot be manipulated.
OPERATING SOFTWARE
The operating software version can be interrogated and, if necessary, updated. When required please
contact your Retsch distributor.
If you have accidentally got into the menu and jumping back into the previous menu is not possible,
switch off the unit at the main switch and restart.
Contrast / Brightness
MENU DISPLAY CONTRAST
BRIGHTNESS
Contrast and brightness can be adapted to each user or to the environment (sunlight, dazzling etc).
If you have accidentally selected the wrong contrast or brightness (the display can no longer be seen), switch
off the unit at the main switch, keep the buttons START, STOP and LID OPEN pressed simultaneously and
switch on again. You are now in the language selection and the setting values CONTRAST and BRIGHTNESS
have the works presettings again.
Date / Time
MENU DATE
TIME
The actual date and time can be entered here.
The time then appears in the stand-by monitor.
The unit can be disconnected from the mains for up to 30 days without the settings being lost.
Stand-by monitor
After 15 minutes inactivity of the unit (times after a STOP command) the stand-by monitor switches on
automatically.
By pressing one of the buttons, or touching the setting knob, the stand-by monitor disappears without carrying
out the command which has been made.
If you were in a sub-menu when the stand-by monitor was activated, you return to this selection window
automatically.
The stand-by monitor cannot be set and cannot therefore be switched off.