Salsbury Industries 9000 Series Storage Cabinets - Manual (Page 2)

2. Place one of the Notch Strips along the right side of the Back with the notches inward pointed up and the Notch Strip holes aligned with the holes
along the right side of the Back. The Notch Strips are symmetrical end-to-end, so either one fits on either the right or left side of the Back.
3. Place the Right Upright along the right side of the Back with the Back and Notch Strip inside the flanges of the Upright and the top of the Upright
at the same end as the top of the Back. The rear flange on the Right Upright is the one with 7 holes. The front flange has only five (5) holes. The
top flange of the Right Upright has three (3) holes while the bottom flange has no holes. Fasten together the Back and the Notched Strip to the Right
Upright flange using seven (7) screws and nuts. Only five (5) screws and nuts go through the Notch Strip. The screws should be inserted from the
inside of the cabinet with the nuts being installed on the rear of the cabinet.
4. Repeat 2 and 3 with the Left Upright and other Notch Strip using another seven (7) screws and nuts.
5. Stand the Uprights and Back assembly up. Insert the Top from the rear of the cabinet underneath the top flanges of the Right and Left Uprights.
The only flange of the Top should be in the rear and pointing downward toward the bottom of the cabinet. The flange of the
Top will be on the outside of the back. Attach the Top to the Upright flanges and Back using ten (10) screws and nuts, three (3) on each side on the
top and four (4) in the rear. See Figure 2.
Figure 2
6. Place the Bottom between the Uprights and fasten to the Uprights and the Back using ten (10) screws and nuts, three (3) on each side and four
(4) in the rear. See Figure 3.
Figure 3
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 04, 1/6/2010) Page 2 of 9