Salter 9147 BK3R Stow-A-Weigh Analyser Scale - Manual (Page 5)

5
gB
diSplAy guide
prepAring your ScAle
1. Open the battery compartment on the scale underside.
2. Insert batteries (1 x CR2032) observing the polarity signs (+ and -) inside the battery
compartment.
3. Close the battery compartment.
4. Select kg, st or lb weight mode by the switch on the underside of the scale.
5. For use on carpet remove the non-slip pads from the scales feet and attach enclosed
carpet feet.
weight reAding only
1. Position scale on a firm flat surface.
2. Tap the platform centre (vibration activates your scale) and remove your foot.
3. Wait until 0.0 is displayed.
4. Step on and stand very still while the scale computes your weight.
5. When you hear a beep, step off.
6. Your weight is displayed for a few seconds then the scale will switch off.
perSonAl dAtA entry
1. When 0.0 is displayed press Set button to activate the set-up procedure.
2. User number will flash. Press ▲ or ▼ buttons as necessary to set the user
number, press Set to confirm.
3. Weight units will flash. Press ▲ or ▼ buttons as necessary to set the units
(kg,lb,St), press Set to confirm.
4. The male or female symbol will flash. Press ▲ or ▼ buttons until the correct
symbol is flashing, press Set to confirm.
5. The age display will flash. Press ▲ or ▼ buttons as necessary to set your
age, press Set to confirm.
6. The height display will flash. Press ▲ or ▼ buttons as necessary to set your
height, press Set to confirm.
7. The normal/athlete symbol will flash. Press ▲ or ▼ buttons to set athlete or
normal mode, press Set to confirm.
Note: An athlete is defined as a person who is involved in intense physical activity of
approximately 12 hours per week and who has a resting heart rate of approximately
60 beats per minute or less.
8. User number will flash. Your user data is now set. Wait for the scale to switch off.
9. Repeat the procedure for a second user, or to change user details.
weight & Body fAt reAdingS
1. Position scale on a firm flat surface.
2. Tap the platform centre (vibration activates your scale) and remove your foot.
3. Wait until 0.0 is displayed.
4. Press Set button. User number will flash. Press ▲ or ▼ buttons as necessary
to select your user number.
5. Your user data will be confirmed, wait until 0.0 is displayed.
6. With bare feet, step onto the scale platform and stand still.
7. When you hear a beep, step off.
8. Your weight will be displayed followed by BMI, body fat, body water and muscle mass.
9. Your weight will be displayed a second time then the scale will turn off.
wArning indicAtorS
err Out of range, incorrect operation or poor feet contact. Unstable weight.
Stand still..
o-ld Weight exceeds maximum capacity.
lo Replace battery.
technicAl SpecificAtion
100 cm - 220 cm Male/Female d = 0.1 BMI
3’ 2” - 7’02 ” 4 user memory d = 0.1 % body fat
10 - 80 years Athlete mode d = 0.1 % body water
d = 0.1 % muscle mass
Advice for uSe And cAre
• Always weigh yourself on the same scale placed on the same floor surface.
Do not compare weight readings from one scale to another as some differences will
exist due to manufacturing tolerances.
• Placing your scale on a hard, even floor will ensure the greatest accuracy and
consistency.
• It is recommended that you measure at the same time of the day, preferably early
evening before a meal for the most consistent results.
• Your scale rounds up or down to the nearest increment.
If you weigh yourself twice and get two different readings, your weight lies between
the two.
• Clean your scale with a damp cloth. Do not use chemical cleaning agents.
• Do not allow your scale to become saturated with water as this can damage the
electronics.
• Treat your scale with care - it is a precision instrument. Do not drop it or jump on it.
trouBleShooting guide
• You must have bare feet when using body fat and total body water measurements.
• The condition of your skin on the bottom of your feet can affect the reading. To get
the most accurate and consistent reading, wipe your feet with a damp cloth,
leaving them slightly moist before stepping on the scale.
guArAntee
This product is intended for domestic use only. Salter will repair or replace the product,
or any part of this product, (excluding batteries) free of charge if within 15 years of
the date of purchase, it can be shown to have failed through defective workmanship or
materials. This guarantee covers working parts that affect the function of the scale.
It does not cover cosmetic deterioration caused by fair wear and tear or damage caused
by accident or misuse. Opening or taking apart the scale or its components will void
the guarantee. Claims under guarantee must be supported by proof of purchase and be
returned carriage paid to Salter (or local Salter appointed agent if outside the UK). Care
should be taken in packing the scale so that it is not damaged while in transit.
This undertaking is in addition to a consumer’s statutory rights and does not affect
those rights in any way. For UK Sales and Service contact homedics group ltd,
po Box 460, tonbridge, kent, tn9 9ew, uk. Helpline Tel No: (01732) 360783.
Outside the UK contact your local Salter appointed agent.
male/female Age
normal/Athlete
height
Body fat
Bmi
Body water
muscle mass
weee eXplAnAtion
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe recycling.
IB-9147-1009-02.indd 5 09/11/2009 16:40