SATEC PM135 Manual - Manual (Page 16)

‎Chapter 1 General Information Measured Parameters
16 PM135 Powermeter Series
Device Resolution
A low or high-resolution option can be selected for the presentation of
voltage, current, and power for use in high and low power applications.
See
Measurement Units for more information.
Energy Rollover
The energy rollover limit can be changed in the meter to provide 4-digit to
9-digit energy resolution. See
Device Options in Chapter 5 for details. The
meter display is capable of showing full 9-digit energy counters using two
LED windows.
Display Options
Different display options are available for customization to be used in dark
or non-safe locations, or in places that are hardly accessible for
observation. See
Configuring the Display in Chapter 5 for more
information.
1.4 Measured Parameters
Table 1: Measured and Displayed Parameters
Parameter Display Comm. Analog Pulse Alarm
1-cycle Real-time Measurements
RMS Voltage per phase    
RMS Current per phase    
kW per phase   
kvar per phase   
kVA per phase   
Power Factor per phase   
Total kW    
Total kvar    
Total kVA    
Frequency    
Neutral Current    
Total Power Factor    
Voltage & Current unbalance   
1-sec Average Measurements
RMS Voltage per phase    
RMS Current per phase    
kW per phase   
kvar per phase   
kVA per phase   
Power Factor per phase   
Total kW    
Total kvar    
Total kVA    
Total Power Factor    
Frequency    
Neutral Current    
Voltage & Current unbalance   
Amps & Volt Demands
Ampere & Volt Demand per phase   