Using pas – SATEC PM135 Manual User Manual
Page 97
Advertising
Chapter 5 Configuring the PM135
Configuring Meter Security
PM135 Powermeter Series
97
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, select
Administration from the Monitor menu, and then select Change
Password -> Password 1.
Figure 5-15: Password Setup Dialog Box
To change the password:
1. Type in a new 4-digit password
2. Repeat the password in the
Confirm new password box
3. Check
Enable
password
protection to enable password
checking
4. Click Send.
Advertising