Schroth Racing Rallye Cross - Manual (Page 4)

INSTALLATION
1 General Instructions
Always leave original equipment seat belts in place and
available for use.
We strongly recommend that you leave the factory installed 3-
point restraint system originally supplied for the front seating
positions of your vehicle as well as those systems originally
installed for the rear seating positions in place when you install
the SCHROTH asm harnessbelt. Removal of original equipment
restraint systems may also violate applicable State or Federal
law.
To carry rear seat passengers, you must use your standard 3-
point factory provided seat belts. To use the factory installed
seat belts after a SCHROTH Rallye 3 or Rallye 4 belt has been
installed you must first release the SCHROTH separation
buckle that connects the shoulder belts to the rear tail strap.
Leaving original equipment systems in place and fully functional
will enable you choose either the SCHROTH Rallye 3/Rallye 4
OR to use the vehicle`s standard seat belts when it is necessary
to transport passengers in any of the rear seats or when either
harness belt is not suited for use by the driver or front seat
passenger.
SCHROTH Rallye Cross harnessbelts must only be installed in
vehicles were rear seat occupation is not intended at any time.
Rallye Cross harnessbelts do not offer a separation buckle for
the rear cross over shoulder straps and therefore severely
restrict access to the rear seat once installed. On 2-door
vehicles the folding front seat backrests will be restricted in their
range of motion. Therefore evacuation and rescue of rear seat
passengers can be impossible after an accident. Heed all
WARNINGS!
W A R N I N G !
On 2-door vehicles the folding front seat backrest
will be restricted in their range of motion. Evacuation
or rescue of rear seat passenger can be restricted or
even impossible after an accident and severe injuries
or death may occur.
W A R N I N G !
Separate SCHROTH asm harnessbelts are supplied
for the left and right sides.
Black asm cartridge must be on the inboard shoulder
strap when system is installed (see illustration).
Never install belt on wrong side of vehicle. System
will not function properly in an accident and serious
injury or death may occur.
4
PACKAGE CONTENTS
Rallye 3
Rallye 4
Installation hardware
Rallye 3:
Bolt 7/16", length 1½" 1x
Bolt 7/16", length 1" 2x
Spacer sleeve 1x
Spring washer 3x
Transparent Sticker (indoor) 1x
SCHROTH asm sticker
1x
Registration card 1x
Rallye 4:
Bolt 7/16", length 1½" 1x
Bolt 7/16", length 1" 3x Rallye Cross (bolt-in)
Spring washer 4x
Transparent Sticker (indoor) 1x
SCHROTH asm sticker
1x
Registration card 1x
Rallye Cross (bolt in)
Bolt 7/16", length 1½" 1x
olt 7/16", length 1" 3x
Spring washer 4x
Transparent Sticker (indoor) 1x
SCHROTH asm sticker
1x
Registration card 1x
Rallye Cross (wrap around)
Bolt 7/16", length 1" 2x Rallye Cross (wrap
around)
Spring washer 2x
Transparent Sticker (indoor) 1x
SCHROTH asm sticker
1x
Registration card 1x
5