Schroth Racing Rallye Cross User Manual

Page 8

Advertising
background image

if the roll bar manufacturer has the bar certified for

shoulder strap attachment. Not certified bars can be

week to keep the forces applied to during an

accident.

Severe injuries or death may occur.


The distance measured between the attached straps must not
be more than 5" (125 mm). In case the bar is located more than
12" (300 mm) behind the backrest of the front seat, we suggest
to attach the shoulder straps close to each other or to overcross
them if the distance of the bar is even larger.

The straps strictly must be wrapped and looped as instructed in
the following paragraph.

W A R N I N G !

Not strictly following the installation instructions

may impair the effectiveness of the attachment. The

straps can be wrapped-off in a crash.

Severe injuries or death may occur.


The adjusting slide bracket must be positioned as close as
possible to the bar.

The strap ends must protrude at least 4" (100 mm) out of the
adjusting slide.

C A U T I O N !

Any damage to the webbing will impair the

effectiveness of the harness belt system!


Most States require that seat belts be worn by all passengers
when a car is in motion. Please check with your local authorities
for further information! Regardless of the law in your State, it
only makes sense to buckle up, so before you start your car,
make sure that you and all of your passengers are properly
restrained.

The SCHROTH asm harnessbelt system when properly
installed and used according to applicable instructions can
mitigate injury. Of course, the ability of any restraint system to
mitigate or prevent injury is directly related to the type and
severity of the accident.

The following pictures show the correct installation and use of
SCHROTH asm harnessbelts for the specific vehicle depicted.
This vehicle body is one of our test devices used to simulate
head-on collisions at 31 mph. Doors and other components not
required for the evaluation of harness belt performance have
been removed.











12

The driver seat is equipped with a SCHROTH Rallye 3 harnessbelt system with the tail
strap installed at the C-pillar (anchor point "C").

Only the passenger seat is equipped with a SCHROTH Rallye 4 harnessbelt system!




W A R N I N G !

Tail strap installation to a lateral bar of a roll bar
is only recommended for Rallye Cross Harnesses











13

Advertising
This manual is related to the following products: