Schroth Racing Rallye Cross - Manual (Page 7)

5 Installation of tail straps
Rallye 3
Positions of suitable anchor points
anchor points are not suitable
If Rallye 3 tail strap is installed at anchor point "C"
If necessary open panel covering at anchor point "C"
use spacer sleeve [1]
Installation if vehicle Installation if vehicle
is equipped with stock is not equipped with stock
3-point-belts for rear 3-point belts for rear
seats. seats.
C A U T I O N !
The tail strap
1. must be installed at a sufficient distance from the stock
3-point belt swivel attachment so the range of motion of
the stock belt is not restricted,
2. must be positioned in direction of the pull of tail strap
when the belt is worn (see illustration).
Rallye 4 and Rallye Cross
Positions of suitable anchor points
anchor points are not suitable
10
If tail straps are installed at anchor point "D"
W A R N I N G !
Never install the harness belt at the lower anchor
point "D" unless it is used with an approved seat.
(See index in Vehicle Reference List.) Installation
with an unapproved seat can result in serious
personal injury or death.
Note:
SCHROTH approval of a non-standard seat for use in
combination with SCHROTH asm harnessbelts installed at
anchor point "D" is limited to suitability of backrest force
deflection characteristics as measured and tested by
SCHROTH.
This limited SCHROTH approval does not constitute an
endorsement of any recommendation made by the
manufacturer of such non-standard seats regarding suitability
for use in a particular vehicle.
Installation with stock Installation without
belts for rear seats. stock belts for rear
seats.
Never remove seat belts supplied as original equipment with
your car.
If tail straps are installed at anchor point "E"
(Rallye 4 and Rallye Cross, refers to Rallye 3 only to specifically
indicated vehicles)
Installation with stock Installation without
belts for rear seats. stock belts for rear
seats.
11
X
X X
X
X X
X
X
X
X
X
X
X