Summit SPF5DSSTBADA - Manual (Page 11)

Felix Storch, Inc.
SUMMIT PROFESSIONAL DIV.
Page 11
INSTRUCTIONS FOR INTEGRATED FRAME (SUFFIX ’IF’) FOR BUILT-IN APPLICATIONS
Note: The directions below are for installation under a cabinet in a 24 inch cutout space. If you will be using this product in a
freestanding application, please skip below, and begin with step A1 in lower half of page.
1. Remove door from chassis by unscrewing 3 screws in top hinge and
2 screws in bottom hinge. Keep screws, discard hinges.
2. Remove top and bottom hinge bushings.
3. Remove frame from door.
4. Attach customer-supplied handle to door panel using countersunk
screws.
5. Screw door panel to frame using 14 screws.
6. Slide frame over refrigerator door and attach with 1 screw on each
side on center of door.
7. Attach top brace to frame with 1 screw on each side. Attach bottom
brace in the same manner.
8. Drill a hole through the top and bottom panel using the braces as a
guide with a 1/8” drill bit. Install screws to finish attaching the top and
bottom braces securely to the frame.
9. Drill a hole into the door panel from the top and bottom using the
braces as a guide with 1/4” drill bit. Do not exceed 5/8” deep. This is
the hole that the door will pivot on.
10. Remount the door using the supplied top and bottom hinges.
INSTRUCTIONS FOR 2-PIECE STAINLESS STEEL FRAME (SUFFIX ‘FR’)