Summit SPF5DSSTBADA - Manual (Page 4)

Felix Storch, Inc.
Page 4
SUMMIT PROFESSIONAL DIV.
INSTALLATION INSTRUCTIONS
CHOOSING THE RIGHT PLACE
Place the appliance in a dry and regularly ventilated place. It is recommended that this appliance always be operated
in an ambient temperature of at least 60°F and under 85°F. The appliance may be exposed to lower or higher
temperatures but only for a short period of time and the temperature should never be lower than 45°F. Never place the
appliance near heat-emitting devices (e.g., oven, radiator, water heater) and do not expose it to direct sunlight.
RECOMMENDED GROUNDING METHOD
A 115 Volt (AC only) 60 Hz grounded electrical supply equipped with a 15- or 20- amp fuse or circuit breaker is required.
It is recommended that a separate circuit serving only your appliance be provided. Use outlets that cannot be turned
off by a switch or pull chain. Connect this appliance to a 3-prong power supply outlet that has a ground terminal. If you
only have a 2-prong outlet, have it replaced by a qualified technician with an outlet that meets the local codes. DO NOT
USE AN EXTENSION CORD. Required nominal voltage and frequency are indicated on the rating plate. The connection
to the power supply and grounding has to be made according to current standards and regulations. The appliance can
resist temporary voltage fluctuations from -15 to +10%.
FOR OUTDOOR MODELS ONLY
Electrical Shock Hazard! Plug into a grounded 3-prong outlet. Do not remove ground prong. Do not use an adapter.
Do not use an extension cord. Failure to follow these instructions can result in fire or electrical shock.
Many outdoor outlets are controlled by wall switches. Turning power off and then on again may cause the GFCI switch
to trip.
A GFCI (ground fault circuit interrupter) is built into every line cord. Do not defeat or bypass this important safety
feature. The line cord supplied with this appliance is specially designed for outdoor use. Use only a factory-supplied
replacement cord with a GFCI in the event the cord becomes damaged.
You may purchase these cords from either our sales or service department at 718-893-3900 (sales) or 718-328-8700
(service) .
They can also be ordered online from www.summitapplianceparts.com
ENERGY SAVING TIPS

The more airflow you can provide around an appliance, the less energy it will use.

If your appliance needs defrosting, keep ice build-up to less than 1/2 inch.

Keep doors or drawers open a minimum of time, and shut securely.
LEVELING YOUR APPLIANCE
1. Locate the two front leveling legs, which may be taped among the packing materials. In most models these legs are
already mounted into the underside of the appliance.
2. Screw these legs into the front holes on the bottom of the appliance. The back of the appliance rests on two fixed
supports. (Built-in models also have rear level legs that can provide more precise leveling).
3. Adjust the front legs just enough to lift the cabinet up off the floor.
4. Place a leveling tool on top of the appliance: first side to side, then front to back. Turn leg counter-clockwise to
raise a corner. Turn leg clockwise to lower a corner.
5. Repeat Step 4 until appliance is level.
6. After appliance is fully loaded, recheck with level as in Step 4.
7. If your appliance is equipped with casters, the two front casters have brakes to prevent rolling. Keep brakes locked,
and unlock for moving only.