Heading2 - using the on-screen menus, Using the on-screen menus, Ee “using the on – BOXLIGHT XD-10m User Manual
Page 24
16
U
s
i
n
g
t
h
e
P
r
o
j
e
c
t
o
r
Using the On-Screen Menus
The projector
has menus that allow you to make image adjust-
ments and change a variety of settings. These adjustments aren’t
available directly from the keypad.
NOTE: Some menu items may be
grayed out (dimmed) at certain
times. This indicates the item is
not applicable to your setup or the
item is not enabled until another
selection is made.
To open the on-screen menus, press the
menu/select
button on the
keypad or remote. (The menus automatically close after 30
seconds if no buttons are pressed.) This displays the Main menu
and changes the source and reset buttons on the keypad to menu
navigation buttons. Press the
button
to move the cursor
down and press the
button to move the cursor up. The
selected menu is highlighted.
F
IGURE
13
Main menu
To change a menu setting, use the up and down arrow buttons to
move the cursor up and down to the item you want to change
(the selected item is highlighted), then press
menu/select
. When
an item is selected, its button appears depressed on-screen. Use
the up and down arrows to adjust the setting or turn it on and off.
Press
menu/select
when you are done. Press the up and down
arrows to move to another setting. When you have completed
your adjustments, navigate to Exit, then press
menu/select
. You
are returned to the top of the Main menu. Press
menu/select
again
to exit the Main menu, or navigate to another submenu.