BOXLIGHT XD-10m - Manual (Page 35)

27
MAINTENANCE & TROUBLESHOOTING
This section describes how to:
• clean the lens
• replace the projection lamp
• replace the batteries in the remote
• use the security lock feature
• troubleshoot the projector
Cleaning the Lens
Follow these steps to clean the projection lens:
1 Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
• Avoid using an excessive amount of cleaner, and don’t
apply the cleaner directly to the lens.
• Abrasive cleaners, solvents or other harsh chemicals might
scratch the lens.
2 Lightly wipe the cleaning cloth over the lens in a circular
motion.
3 If you don’t intend to use the projector immediately, replace
the lens cap.
Replacing the Projection Lamp
WARNING: To avoid burns,
allow the projector to cool for at
least 30 minutes before you open
the lamp access grill. Never
extract the lamp module while the
projector is operating.
The lamp hour counter in the Status menu counts the number of
hours the lamp has been in use. Change the lamp when the
brightness is no longer acceptable. You can order new lamp mod-
ules from B
OXLIGHT . See “Accessories” on page 36 for informa-
tion.
Follow these steps to replace the projection lamp:
1 Turn off the projector and unplug the power cord.
2 Wait 30 minutes to allow the projector to cool thoroughly.