Bushnell TROPHY CAM 119425C2 - Manual (Page 19)

19
Parameter Settings
(Bold=default)
Description
Interval 10S (second)
default,
with a 60M
(minute) to1S
(second) range
of settings
available.
(60M-1M are set
in one minute
increments,
59S-1S are set
in one second
increments)
Selects the length of time that the
camera will “wait” until it responds
to any additional triggers from
the PIR after an animal is first
detected and remains within the
sensor’s range. During this user
set “ignore triggers” interval, the
camera will not capture photos/
videos. This prevents the card
from filling up with too many
redundant images. Settings
begin with 10 second default
when parameter is first selected.
Note: after setting down past “1S”,
settings start over at “60M”.
Sensor Level Normal, High,
Low Selects the sensitivity of the PIR
sensor. The “High” setting will
make the camera more sensitive
to infrared (heat) and more
easily triggered by motion, and
the “Low” setting makes it less
sensitive to heat and motion. The
High setting can be useful when
the ambient temperature is warm
(making it more difficult for the
sensor to detect animals), and
the Low setting may help in cold
weather if the camera is being
triggered too often by anything
warmer than the surroundings.
The SETUP Menu-Parameters and Settings List w/Descriptions