Bushnell TROPHY CAM 119425C2 - Manual (Page 21)

21
Parameter Settings
(Bold=default)
Description
Field Scan On, Off Turns Field Scan (Time Lapse)
recording mode on/off. Pressing
OK with On selected will go to
the Set Field Scan screen, which
allows you to set the Start and
Stop times in hours (0-24) and
minutes (00-59).This is setting
the time each day for recording
to begin and end (24 -hr clock, so
13:00 hours=1PM). Use the RIGHT
key to step through the fields,
and use UP/DOWN to change
the settings. After you set the
“Stop” minutes, the next press of
the RIGHT arrow key will jump to
the screen for setting the Interval
(how often the Trophy Cam will
wake up and record). You can
select 60, 30, 15, 5 or 1 minutes
(default is 5M).
Default Set Cancel, Execute Select “Execute” and press OK
to restore all parameters to the
original factory default settings. If
the camera is behaving oddly and
you think you may have changed
the setting for something
accidently (but aren’t sure which
one), this will reset all parameters
to their most commonly used or
“generic” settings.
The SETUP Menu-Parameters and Settings List w/Descriptions