Summit TDC111V User Manual - Manual (Page 12)

5 Press the Start button
Remaining drying time
An estimate of the remaining drying time
will be shown on the display a few minutes after
the drying program starts. For example, "1:35"
means it will take approximately 1 hour and 35
minutes for the load to dry.
The actual remaining time may be longer than the
estimated time shown on the display. The
remaining time is then shown as "0:15" until the
laundry is sufficiently dry.
Stopping or changing a program
Press and hold the Stop button for three seconds.
NOTE!
The program will not be affected if you change
the program selector after the program has
started.
Loading or removing laundry
You can stop the tumble dryer after starting a
program by opening the door. Load more laundry
or take out the items you want, close the door,
and press the Start button. A new estimate of the
remaining program time will be displayed after a
few minutes.
6 Drying program finished
The text "End" appears on the display when
the program is finished.
Backlighting
Two minutes after the drying program finishes the
backlighting on the display and option buttons
enters energy saving mode.
NOTE!
• Clean the lint filter after each load.
To install the automatic drain hose, please see
the section titled Installation
WARNING!
If the lint filter becomes clogged, the machine’s
automatic overheating cut-off may be triggered.
In order to be able to restart the machine, you
must clean the filter and allow the machine to
cool down for around 30 minutes.
Once drying has finished
Turn off the main power switch. Remove the
clothes and close the door to prevent small
children from climbing into the machine.
Customer Care Center
1-800-898-1879
12
www.askousa.com
Operating instructions