Summit TDC111V User Manual - Manual (Page 28)

You can choose whether the door is hung on the
right or the left.
Follow these instructions:
1. Remove the Toe kick.
2. Remove the hinge (two screws).
3. Lift the door up and remove it. Support the door
while doing this.
4. Remove both door pins (top and bottom). Fit
them on the other side of the machine. Replace
the hinge.
5. Loosen the screws (13 in total) on the inside
of the door.
6. Loosen the inner part of the door (pull down
and lift out).
7. Switch the catch (magnetic lock) and the cover
plate. First loosen the screw holding the catch
(magnetic lock) in place. Then use a flat
screwdriver to remove the cover plate. Replace
the catch (magnetic lock) and the cover plate
on the other side.
8. Replace the inner part of the door with the
screws (13 in total).
9. Move the plastic plugs on the upper and lower
edges of the door. Use a flat screwdriver to
remove the plugs.
10. Loosen the two screws holding the handle in
place on the door. Push out the two plastic
plugs inside the screw holes on the other side
of the door. Use the two screws to attach the
handle to the other side of the door and press
the plastic plugs into the holes where the
handle was previously fitted.
11. Refit the door by loosening the hinge screws
slightly, affixing the door, and closing it.
Retighten the hinges. Replace the Toe kick.
Customer Care Center
1-800-898-1879
28
www.askousa.com
Reversing the door